High quality aluminum alloy material, energy saving and environmental protection aluminum alloy pipeline

Energy saving ring aluminum alloy pipe description, high quality aluminum alloy material, coated with epoxy resin, and the inside of the pipe after special treatment to avoid oxidation, inner surface smooth, never corrosion. FST air piping system delivers high quality air from the gas production end to the use end anytime and anywhere to ensure the continuity and stability of downstream equipment and production process. At the same time, anti-corrosion, no leakage characteristics, long time operation, ensure zero leakage in the process of air transmission, effective prevention and control of energy loss.

The smooth inner surface, full diameter, internal diversion and other optimization design reduce the air flow resistance, the pressure drop of the pipeline is relatively low, the flow rate is relatively good, the operation cost caused by the pressure drop is as much as 5% (the pressure drop reduces the energy consumption of the installed power by 7%). Compressed air aluminum alloy pipe, with high-performance o-type sealing ring, to ensure better sealing, no leakage use.

With corrosion resistance, mechanical vibration resistance, strong fire resistance, heat and cold weather change ability, can adapt to a variety of adverse environment, to ensure safe, stable, high quality clean air transport to the end of use, and ensure the pipeline surface clean, effectively ensure the service life of terminal equipment and stable quality of products.

Ensure that the pneumatic pipeline ball valve installation position pipeline in the coaxial position, the two flanges on the pipeline should keep parallel, confirm that the pipeline can bear the weight of the pneumatic pipeline ball valve itself, if it is found that the pipeline can not bear the weight of the pneumatic pipeline ball valve, the pipeline shall be equipped with the corresponding support before installation.

Dalian aluminum alloy pipeline to confirm whether there are impurities in the pipeline, welding slag, must be swept clean the pipeline. Check the nameplate of the ball valve of the pneumatic pipeline, and operate the ball valve of the pneumatic pipeline with full open and full close for several times to confirm that the valve can work normally, and then check every detail of the valve comprehensively to ensure that the valve is intact. In addition to the valve two protection cover, check whether the body is clean, clean the body cavity, because the sealing surface of the pneumatic pipeline ball valve is a ball shape, even small debris may cause damage to the sealing surface.